Skip to content
DentonGate Repair

Gate Electrical and Wiring Repair in Denton County

Acreage gates sit a long way from the house, out in the open, in lightning country. That makes wiring the weak point on a lot of Denton County gates. We trace the electrical side from the power source to every sensor and fix what failed. Any brand new line-voltage circuit is a job for a licensed electrician.

Open 24 hours, 7 days a week

Gloved hands using a wrench on the post bracket that holds a swing opener arm

What you might be seeing

Solar wiring and charging

Most rural gates here run on solar. The panel feeds a charge controller or the board, which charges the battery, which runs the opener. Any weak link in that chain, from a corroded connector at the panel to a cracked cable where it enters the box, can leave a gate dead with a perfectly good panel and opener.

We test panel output, the charger and the battery under load, then trace and repair the wiring between them. If the panel simply cannot keep up with how often the gate runs, we may suggest a larger panel or battery.

Long runs, underground wiring and low-voltage control wiring

On larger properties in Argyle, Aubrey, Krum and Sanger, a gate fed from the house may have a very long low-voltage run. Wire that is too thin for the distance never delivers full voltage, and splices along the way corrode over time. Buried cable without conduit is also easy to cut with a post hole digger or a box blade.

We measure voltage at each end of the run with the gate moving, find the break or the weak splice, and repair it or pull new wire. Where a new route is needed, we explain where it will go before any digging.

Transformers, chargers, relays and boxes

Electrical repairs we handle at the gate include:

  • Transformer, power supply and battery charger replacement
  • Solar charge controller and panel wiring repair
  • Relay, contactor and fuse replacement
  • New junction boxes, terminal blocks and sealed enclosures
  • Rewiring chewed or corroded connections
  • Surge protection and grounding at the opener

Lightning and water damage

A strike does not have to hit the gate to damage it. A surge can travel along a long buried wire or the power line and take out the board, the receiver and the charger in one go. We test each part to see what survived, and we look at grounding and surge protection so the next storm does less.

Water does its damage more slowly. Boxes mounted close to the ground, conduit that faces up, and splices left unsealed let moisture in. We seal or replace the enclosure and move it up out of the splash and flood line where we can.

AC-to-solar conversion, and when you need an electrician

Bringing new AC power to a gate a long way from the house can mean a lot of trenching. Converting to solar is often the simpler answer. In other cases, a heavily shaded gate or a gate that runs all day does better on AC. Either way, we take care of everything on the gate side.

We are not electricians. Any new line-voltage circuit, outlet or breaker for the gate is installed by a licensed electrician. We tell them what the opener needs and connect the gate equipment once power is there.

Pricing

Cost depends on where the fault is, how much wire has to be replaced, any trenching, and which parts were damaged. Call for pricing and ask about current discounts.

Quick checks from the driveway

  • Check the solar panel for cracks, shade, dust or loose wires
  • Reset the breaker or GFCI outlet on AC gates
  • Look for status lights on the board and charger
  • Look for chewed or cut wire where cables enter the control box
  • Leave the control box shut if it is wet inside or smells burnt

Stay clear while it misbehaves

Line voltage around wet ground and steel gates can kill. Turn power off at the breaker before opening a control box, and stay away from any box that is scorched or full of water. Solar batteries can deliver a large current too, so do not short their terminals. New household circuits are work for a licensed electrician.

Questions people ask us

My solar panel looks fine, so why will the battery not charge?

The fault is often in the wiring, a connector or the charge controller between the panel and the battery. We test each piece under load.

Why does my gate run slow at the end of a long driveway?

Long low-voltage runs lose voltage, especially if the wire is undersized. Heavier wire, a closer power supply or a switch to solar can fix it.

Can a lightning strike nearby damage my gate?

Yes. Surges can travel along power and control wires. We test the board, receiver, charger and accessories and add surge protection where it makes sense.

Do you install new electrical service at the gate?

No. A licensed electrician installs any new line-voltage circuit. We handle the opener and the low-voltage and solar wiring.

What does gate wiring repair cost?

That hinges on where the break is, how many feet of wire it takes and whether we have to dig. Call (940) 240-2402 for pricing and ask about current discounts.

Other gate work we do

Gate Wiring Repair in Denton County: call any hour

We pick up 24 hours, 7 days a week. Call for pricing on your gate. Ask about current discounts when you call.

Call nowGet a quote